FISHER PH-D340 Volume control problem

[stereomann]

the volume control is at full volume on the right speaker when turned all the way down
i tried taking it out and cleaning it but it still does the same thing
it seems like it had old sticky grease in it or something
i noticed if i wiggle the post on the control there will be no sound at zero

i plugged some pc speakers with a volume control into the headphone jack so it won't be as loud when testing it & to not blow the original speakers.

it was working fine last year when i used it so I'm not sure what happened
i don't think i will be able to find a replacement knob because it's from 1994

 

[BoomboxLover48]

It appears like the feelers in it is broken off. Did you open up the the volume pot? I would open it up carefully and inspect the inside carbon disc and feelers.
Those volume pots are not easy to find. I think Panasonic RX 5350 pot is also similar.

 

[stereomann]

I took it apart but didn't see anything broken but maybe there could be. I was thinking of adding a different volume control somewhere else on the unit. Like one of the speaker controls they sell that you put in a wall. one side you hook to the amp and the other to the speakers. And just leave the original control where it sounds good and both channels play.

 

[stereomann]

Something like this but maybe something a little cheaper and smaller.

 

[floyd]

I might have this part for you brother I have a 6-pin potentiometer that's identical I don't know where it came from but I have it.

 

[caution]

Hey Floyd that's got a loudness tap, I see seven pins.
A normal 6 pin pot will work but you'll have no bass at low volume.
These are very hard to find, almost easier to pillage a known junker for one.

 

[BoomboxLover48]

It's a 7 pin one. So rare!

 

[floyd]

Understood thanks fellas.

 

[stereomann]

would something like this work?
i can hook the speaker out to one side & the speakers to the other

RCA Stereo Volume Controller For Amp Preamp Speaker CD Player - No Power Needed | eBay

It can also be used to adjust the music power level of an amplifier or subwoofer system, stereo or equalizer form any part of an amplified system or the dashboard in a car. Audio Interface: RCA x2 for stereo input with RCA x 2 for stereo output.

www.ebay.com

 

[floyd]

would something like this work?
i can hook the speaker out to one side & the speakers to the other

RCA Stereo Volume Controller For Amp Preamp Speaker CD Player - No Power Needed | eBay

It can also be used to adjust the music power level of an amplifier or subwoofer system, stereo or equalizer form any part of an amplified system or the dashboard in a car. Audio Interface: RCA x2 for stereo input with RCA x 2 for stereo output.

www.ebay.com

If the speakers have RCA jacks then this should work.

 

[stereomann]

would one of these 7 pin ones work?

2 x 14mm ALPS RK14 B100K Potentiometer With Center Detent 7-Pin Horizontal Mount | eBay

Find many great new & used options and get the best deals for 2 x 14mm ALPS RK14 B100K Potentiometer With Center Detent 7-Pin Horizontal Mount at the best online prices at eBay! Free shipping for many products!

www.ebay.com

2 x 14mm SoundWell RK14 A50K 50K Audio Taper Potentiometer 18mm D Shaft 7-Pin | eBay

Find many great new & used options and get the best deals for 2 x 14mm SoundWell RK14 A50K 50K Audio Taper Potentiometer 18mm D Shaft 7-Pin at the best online prices at eBay! Free shipping for many products!

www.ebay.com

NEW 100k ohm DUAL Audio Taper Pot PC Board Pins 7-Pin G | eBay

Find many great new & used options and get the best deals for NEW 100k ohm DUAL Audio Taper Pot PC Board Pins 7-Pin G at the best online prices at eBay! Free shipping for many products!

www.ebay.com

 

[caution]

would one of these 7 pin ones work?

According to Alps, the RK14 pots don't use the end pins (1 and 7). No loudness taps.
Only the five center pins are used, because GND is a shared pin.

Did you look at the item description for the third one you listed?
It shows that it has separate L/R GND pins, so only one pin is unused. Again, no midpoint taps.

 

[Tinman]

Here are a couple of my past threads that might help you.
https://boomboxery.com/forum/threads/ge-volume-potentiometer.31794/#post-388281
https://boomboxery.com/forum/threads/m90-volume-pot.31023/#post-382100
Btw, you're showing 100k and 50k pots above, you should verify what your original one is.