Need help with a choice

Status
Not open for further replies.
S

Ser182

Member (SA)
I did the Reli and it was still low. I am going order another cable. Is there a way to clean the RCA's?
 
Reli

Reli

Boomus Fidelis
Ser182 said:
I did the Reli and it was still low. I am going order another cable. Is there a way to clean the RCA's?
Click to expand...
The cable is not the problem. The problem is somewhere inside the box. Maybe the DIN input on the back of the box is dirty. You could try to clean it with some DeOxit. Or maybe the Record switchboard inside the box is dirty. You would have to take it apart and clean it.

Or maybe there's nothing you can do about it.
 
S

Ser182

Member (SA)
Here is the Blockbuster and RX 5050 linked up and connected with an ipad.
[youtube]Mq24RLDMqGI[/youtube]

Thanks Reli i am going to have to go through it fully. Is the DeOxit at the any hard wear store?
 
S

Ser182

Member (SA)
Can deOxit clean PCB? My plan is to use a electronic compressed air to get the dust out. Then clean with DeOxit? Water based or not?
 
Reli

Reli

Boomus Fidelis
Ser182 said:
Can deOxit clean PCB? My plan is to use a electronic compressed air to get the dust out. Then clean with DeOxit? Water based or not?
Click to expand...
You talking about the board with the Record slider?
 
Reli

Reli

Boomus Fidelis
Right but one of the boards has a long, white slider that is activated by the Record switch. You could try spraying that, assuming it's safe to do so. There are 2 or 3 types of DeOxit, some are advertised as being safer for plastics.

Honestly though, all of my boxes sound lower on Aux than they do on Radio.
 
S

Ser182

Member (SA)
The deoxit worked very well. It did improve the volume on all three boxes.
Do you know what beat cancel is? I have A, B, and C.
 
Status
Not open for further replies.
Top Bottom