Ok, I took the player apart and measured the width of the motor bulge where the flat belt runs and it's .199" so the FRW10.7 I referred to would be too wide.
I just ordered my belts, hopefully they work:
FRX10.7 which is .155" wide
SCY3.5
SCY4.2
SCY5.2 - counter
Plus I also ordered two more for my next box project.
I ordered them on ebay which came out to $.30 more than their website with the estimated shipping.
I figure ordering through ebay includes insurance since if they're damaged or don't show up, I can file a claim and recoup my money.
Whenever you get a chance, can you please let me know where the small gray wire goes?
I'm assuming the yellow one goes to the switch with the other yellow wire but I'm not sure where that gray one goes.
It's possible that it also goes to the switch but I'd appreciate you letting me know.
This screw is stripped so I have to come up with something to hold both plates down.
Most likely the same guy who stripped the screw put that short belt on it.
I don't know if you've taken yours out yet but here's a shot of mine somewhat broken down.
It's greasy, oily and dirty but not bad to actually work on.
![PXL_20230129_173458176[1].jpg](/forum/data/attachments/40/40514-3b73b0d30eff2e66d80fd4067073d94c.jpg)