I tried like hell to 3d scan one of these things and finally took the time to use Tinkercad. So, here it is. Be careful removing the support from the model. I made mine in glow-in-the-dark green along with my sliders. When I finally get this put back together the controls will be seen! I might try some wood filament to give it a woody-look. I want to remind you that I have not put it together to see if it works, yet, but it does fit nicely at the top and the bottom might need to be sanded. I hope this helps everyone. I also printed a battery cover but I need to re-measure it a bit to meet my standards. I will post this shortly after I continue my long quest to re-assemble this monster. For some reason the attachment for the .stl file didn't upload.
