Long shot but, is there a Pedro on this forum that did some 3d printing for conions c100?

Status
Not open for further replies.
80sbmx

80sbmx

Member (SA)
Long shot but, is there a Pedro on this forum that did some 3d printing for trim work for conions c100 boomboxes at one time?
 
80sbmx

80sbmx

Member (SA)
The trim that goes over the bottom tape deck buttons..
 

Attachments

  • 20220303_024538.jpg
    20220303_024538.jpg
    84.8 KB · Views: 8
Status
Not open for further replies.
Top Bottom