JVC PC37 one channel OFF in stereo mode

Status
Not open for further replies.

bendera

New Member
Hi,
I can't find a service manual for JVC PC37. The problem is exist only in stereo mode, when i switch to Mono, sound comes to both speakers. Same for Tape and Radio source. Just ordered a contact cleaner, but not sure it will help. Any ideas where to look for a cause? Thanks!
 

dubout

Member (SA)
Contact cleaner might already be the solution. But be careful, some contact cleaners contain aggressive chemicals that help at first but degenerate the insides of the switches after a while and destroy them! I mainly use Kontakt Chemie WL which is only for cleaning. That mostly does the trick. Then there is Kontakt Chemie 61 of which I don't know if it is bad for contacts?! I only use it when I dont care too much about the boombox but had no troubles so far. The most aggressive is Kontakt Chemie 60 which I wouldn't recommend unless it is washed out afterwards – with Kontakt Chemie WL for example.
 

bendera

New Member
The problem is not easy to resolve. I received a contact cleaner and all switches were sprayed. Now Radio works in both Mono/Stereo modes, but Tape is not fixed. Only Mono and only in Reverse mode, direct play is producing a very weak signal.
 
Status
Not open for further replies.