Aiwa TPR-950/955 parts.

Status
Not open for further replies.
Hisrudeness

Hisrudeness

Member (SA)
Hi,
I‘m looking for some parts, if you have any you can part with it would be appreciated.

on/off toggle cap
‘Aiwa’ badge
x1 white tip aerial.

Thanks in advance.
Rudey
 
Hisrudeness

Hisrudeness

Member (SA)
Thanks Tre for the aerial. He’s been a great parts trading partner over the years.

Still looking for a toggle switch and most importantly the front badge.
 
Demonfinder

Demonfinder

Member (SA)
I`ve finally posted off my TPR 950 aerial clip to a small 3D printing company to have a go at measuring and drawing up a blueprint to make a few copies.
They`ve said it may take a while due to a backlog of orders then they will send me a sample to check before they make a small batch.
If this turns out succesfully I can see if they might be able to do the same for toggle switches.
Am I correct in assuming the toggles are just a tight push fit?
Do both the 950 and 955 have orange coloured horizontal bars on the ends?
In future I might even be able to get replacement control knobs if the little company is able to do small production runs and I can spread the cost by offering at cost to othe Boomboxery members in need.
Martin
 
Demonfinder

Demonfinder

Member (SA)
deech said:
Does this front face part from an AIWA TPR-950 suit your needs?
deech said:
Does this front face part from an AIWA TPR-950 suit your needs?
View attachment 53451
Click to expand...
Hi,
Thanks for the posting but luckily I don`t need it.
Maybe a fellow member might need it for replacement grills possible..and I know Hisrudeness is after a front Aiwa Badge for a 955 so this might be of use to him as the badges were the same I think.
I`m sure he`ll be along at some point to check it out.
Click to expand...
 
Status
Not open for further replies.
Top Bottom