100% complete and and 100% running
- Thread starter nz boom
- Start date
- Status
skippy1969
Boomus Fidelis
fresh produce
Member (SA)
thats bad ass 
Jboogie2384
Member (SA)
Damn NZ I don't know how you do it but you have some amazing collection!!! Not hating but DAMN!! I'd love to see your boom room and roll around in it. Congrats!! 
kraftmatic
Member (SA)
BoomboxLover48
Boomus Fidelis
That is Awesome! 
Power pack with crisp and clean sound!
I hope the speakers don't have foam surrounds.
That killed all my excitement after going through terrible pain rebelting the twin decks on my 11W.
I went only at 1/3rd of the volume to kill the rotten foam surrounds.
I am totally confused on putting surrounds for these APMs. How do I center it? Okay I made the surround but how will I center it?
No place to use any shims.
It will be all trial and error, moving the cone and checking if voice coil rubs or not before one glue the sides on the edges of the speaker frame.
Power pack with crisp and clean sound! I hope the speakers don't have foam surrounds.
That killed all my excitement after going through terrible pain rebelting the twin decks on my 11W.
I went only at 1/3rd of the volume to kill the rotten foam surrounds.
I am totally confused on putting surrounds for these APMs. How do I center it? Okay I made the surround but how will I center it?
No place to use any shims.
It will be all trial and error, moving the cone and checking if voice coil rubs or not before one glue the sides on the edges of the speaker frame.
Ghettoboom767
Member (SA)
floyd
Boomus Fidelis
BoomboxLover48 said:That is Awesome!
I hope the speakers don't have foam surrounds.
That killed all my excitement after going through terrible pain rebelting the twin decks on my 11W.
I went only at 1/3rd of the volume to kill the rotten foam surrounds.
I am totally confused on putting surrounds for these APMs. How do I center it? Okay I made the surround but how will I center it?
No place to use any shims.
It will be all trial and error, moving the cone and checking if voice coil rubs or not before one glue the sides on the edges of the speaker frame.
if you glue the surround to the cone first then let that dry , then glue the foam to the frame pushing in on the cone at times to insure there's no coil rub ,if it does rub just manipulate the cone until it moves freely . once you are satisfied there's no rubbing just make sure everything stays pressed down on the edges and allow it to dry .
- Status