Just did a rebelting on a roller series 1
taking off 6 screws, the tuning knob and the function slider
open rrrroller
take off the left screw of the function slider (right one can stay)
Only for lifting up a bit
take off the 2 screws of the circuitboard and take care of the clip (red)
Not take out, only lift up a bit
Take off the screw of the recordslider and the one of the wheelplate.
So you can lift it up a bit and take off the old belt and implant the new one.
Ok, looks easier to implant the belt as it is, i nearly broke my fingers to get it under the plate on the left side
but finally it rrrrrolls again
Happy again
taking off 6 screws, the tuning knob and the function slider
open rrrroller
take off the left screw of the function slider (right one can stay)
Only for lifting up a bit
take off the 2 screws of the circuitboard and take care of the clip (red)
Not take out, only lift up a bit
Take off the screw of the recordslider and the one of the wheelplate.
So you can lift it up a bit and take off the old belt and implant the new one.
Ok, looks easier to implant the belt as it is, i nearly broke my fingers to get it under the plate on the left side
but finally it rrrrrolls again
Happy again