Crown csc 950 tweeter
- Thread starter lazanas
- Start date
- Status
two pieces are melted to hold it 
i need to clean this babe 
You can use long nose pliers to break edges or exato knife to cut then when you replace you can remelt other prongs with solder iron 
good luck 
good luck A solder iron with a big flat tip and you essentially "cut" that plastic weld off, or get a tiny butane torch lighter and heat up the plastic welds while prying up gently on the speaker. OR, you could try to drill the "head" of the weld off 
.
.
will do that! Oh and Blu! You are about to have 2222 posts 
- Status