Lasonic TRC 935 & 975 belt sizes
- Thread starter Lasonic TRC-920
- Start date
- Status
Yes, I did not replace that onebaddboybill said:There should be a 3rd belt too, 1 on deck A and 2 for deck BLasonic TRC-920 said:
I'm trying to replace my belts on the TRC 935 but i'm not sure if I have the right belt sizes. I bought the SBS 10.0 & 6.2s, and since there weren't any SBS 5.0s in stock i didn't get those. Anybody have any experience replacing these because the 10.0s seem a little too big to fit on deck B. The photo above doesn't look like my unit as I seem to have a separate motor for each deck. So if anyone have any photos or tips that'd be much appreciated.
Yes the 10 won't work on dual motor. You need to measure old belts and deduct about 5-10% for stretch
Bad Boy Bill
Bad Boy Bill
Anyone have any idea what the correct belt sizes are for the TRC-935? The belts are in pieces and not sure which pieces are part of which belt so its kind of hard make measurements.
I replaced belts before on my 935 but forgot to put down sizes. But you might be able to buy belt kit too and fit them that way and just pick best size
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
- Status