Aiwa TPR-945E HELP!

Status
Not open for further replies.
Hi I took my Aiwa 945 apart a pretty long time ago and didn't have the time to get at it 'till today, had to reclean even! But now I'm kinda stuck in the middle of something and don't wanna blow it. I thought I'd ask for some help with some little cables (I think are grounds) and one for the FM (i think) I wanted for you to take a look and help em reconnect?

Here are the pics:
That little post right in the middle of the picture belongs to the FM selector switch but the next picture is the connector that goes to it?


Is this the little connector that goes there?


This is the black little cable that goes to a little swich on the back of the Aiwa, any ideas where it goes?


And this is the last white cable also for the same switch. HELP!!!
 

Superduper

Member (SA)
Nope. I don't have an Aiwa 945. I have a 955 and a 990. However, I do not believe it will make a difference. One is a ground rod and the other is for the aerial rod. Since both rods are floating rods (not attached to anything else) it should not matter. However, if it was me, I would put the ground (black) on the side where the transformer is, and the white on the opposite side. sometimes you can tell where they go by the length of the wire of the natural curve. All I can say is try it and see which side works best for you. I honestly don't think you'll be able to tell the difference.
 
Status
Not open for further replies.