Willtech MG-930E Superjumbo

So this arrived today and the first thing I heard was rattling inside the box....not good.

So I opened her up and this piece wasn't secured down and the little wires have broken off. Does anyone have any info as to which connector these have to be soldered back to or does anyone have a service manual where I can try and figure it out?

Thanks all.

That's just the AM/MW antenna, right? Those are usually just glued to the tuner board.

That's going to be tough to restore, usually those fine wires from the ferrite core just get soldered at various points on the tuner board.

Thanks for the replies.

One of the wires is still connected to the tuner board, they're numbered 1-6 on the board but God knows what order they're supposed to go in. If it's for the AM/MW then I might just leave it for now and just clean her up.
.

.