Worth fixing?
- Thread starter Reli
- Start date
You might be able to drill, tap it, and install some kind of fastener to make it functional again. Or I bet trommelmops could come up with some solution.
As for JB weld, it’s great but no, I don’t think it will work nor would I trust it in this case.
As for JB weld, it’s great but no, I don’t think it will work nor would I trust it in this case.
Find a screw of the right size, shape the head, drill and use 2K epoxy on the screw thread to bond it well in the drilled hole.
I would use a screw with a thread that will begin like after 4 mm.
I would use a screw with a thread that will begin like after 4 mm.
Looks like there's something else rattling around inside, maybe a washer or clip that holds it in there. I'll retreive it and see if it's realistic to make something that would fit it. I might just look for a donor handle instead. Pretty sure Hitachi used the same handle on many models.
Damn, that's a tough break ( 
) Other than drilling and putting a screw in, not sure what could be done with this
) Other than drilling and putting a screw in, not sure what could be done with this