Jump to content


Ph 492 very dusty inside

  • Please log in to reply
6 replies to this topic

#1 Mark17

  • Members
  • 3 posts

Posted 12 December 2016 - 12:39 PM

Hello. I took the back off of my pH for 92 yesterday to remove some paint Speckles on the back panel. I know that's an awful lot of dust over everything inside. Is there a viable way to clean some of the dust out of the inside without possibly damaging the inner workings?

Attached Files

#2 superlew

  • Members
  • 1,087 posts
  • LocationWoburn, MA

Posted 12 December 2016 - 03:21 PM

Canned air and a vacuum cleaner wouldn't be a bad start. Use the vacuum to catch what you loosen up with the canned air. Just go easy.


Looks like a beauty on the outside. :yes:

#3 Reli

  • Boomus Fidelis
  • 4,626 posts
  • LocationUSA

Posted 12 December 2016 - 03:25 PM

And then use a dry paint brush after that

#4 Fatdog

  • Administrators
  • 9,808 posts
  • LocationMiddle Tennessee, U.S.A.

Posted 12 December 2016 - 05:05 PM

And then use a dry paint brush after that

^^^ What he said.  :yes:

#5 Cpl-Chronic

  • Members
  • 1,890 posts
  • LocationWindsor, Ontario, CANADA

Posted 12 December 2016 - 05:09 PM

And then use a dry paint brush after that

i use this trick to clean computers out too....especially to clean fans & heatsinks....just be careful around caps & coils...too much scrubbing force can damage stuff...

#6 Mark17

  • Members
  • 3 posts

Posted 13 December 2016 - 09:14 AM

Thanks guys. I will start with your suggestions. Canned air sounds good. I can do that

Attached Files

#7 baddboybill

  • Boomus Fidelis
  • 10,658 posts
  • LocationIn the middle of nowhere!!

Posted 13 December 2016 - 09:22 AM

Best way is first take the electronics out to blow out dust/dirt and clean the case inside with light soap and warm water. This unit comes apart by removing back panel and front panel with frame of Electronics out ;-)