I've got bored by National RX-7200s, so got myself a GF-999.
There is nothing much there for me to do in terms of FM tweaking since it's already there.
So all I need to do is a basic restoration - clean-up, lubrication and belts replacement.
I need some advise on pinch rollers sizes please, the seach did not reveal actual mm dimentions. Since National uses a unique from the common size I won't be surprised Sharp followed the lead. I'm pretty sure they are same size as GF-777 brother but I don't physically have the box to measure the old ones.
And also possibility of installing GF-777 power supply PCB? I'd imagine that I'd need at least to cut a hole in the rear case for round voltage selector. Or maybe install a proper size transformer hardwired for 120vac onto original pcb like I did in the past.
There is nothing much there for me to do in terms of FM tweaking since it's already there.
So all I need to do is a basic restoration - clean-up, lubrication and belts replacement.
I need some advise on pinch rollers sizes please, the seach did not reveal actual mm dimentions. Since National uses a unique from the common size I won't be surprised Sharp followed the lead. I'm pretty sure they are same size as GF-777 brother but I don't physically have the box to measure the old ones.
And also possibility of installing GF-777 power supply PCB? I'd imagine that I'd need at least to cut a hole in the rear case for round voltage selector. Or maybe install a proper size transformer hardwired for 120vac onto original pcb like I did in the past.