tweeter for old sharp GF-9090

I had the front cover off and noticed that the RH side tweeter's small contact PCB came unglued from the body of the tweeter.

I am looking for the wires leading into the tweeter to solder the contacts back and glue the board back down, I do not see them!

I looked at the tweeter on the LH side but I cant see much of anything as it's covered in a thick glob of glue. I don't want to touch it too much, or I may be faced with another broken tweeter!

Is the very thin voice coil wire supposed to be soldered right to the contact PCB? I'm thinking the wire has probably broke off and retreated back into the body of the tweeter after contact board came unglued.

I know this is an old post but I have the same problem so thought I would ask if you managed to solve this?

I'm looking around for new replacements that could fit or may replace the main speakers with coaxials at last resort.

Andy.