Can anyone tell me where these wires should go? They connect to the board near the function switch, as shown in the photo...
Sadly I don't have a schematic. I can't see any place they would come from. The connector next to the wires goes to the head amp board. I figure it has something to do with the tape section.BoomboxLover48 said:
I wanted to help but sadly I don't have a RX 5250.(one Panny I don't have on my collection in the heavy weights of RX series) Just wondering if you could find the other end of these wires hanging inside the unit., or could have pulled out from a connector of solder joint.
I would look up in the schematics and figure it out from where they are coming out/origin.
Macdude443 said:Everything works as it should.
I thought about that. I haven't recorded anything to a tape yet, but I do get levels on the VUs. It probably does have something to do with recording.BoomboxLover48 said:Macdude443 said:Everything works as it should.
The long switch is the record function switch. Did you check recording?
baddboybill said: